Page 5
The installation
The ADSL line and the ADSL modem
The installation of the ADSL line is outside the scope of this manual. This also applies for the ADSL modem. Please
read the documentation you have received from your ADSL provider and/or ADSL modem supplier.
Preparing the SAS100
1
Remove the packaging material.
2
Mount the supplied plastic bumpers under the product to prevent damaging the surface on which the product will
be placed.
3
Place the product on a location close to an ethernet interface or ADSL router and mains power supply.
Connecting the product with an audio installation
The audio installation needs to be connected to the Mic-input or the Line-input of the product.
We strongly recommend you to use the Line-input for this.
In case you have problems with hum or noise, it is advised to install an audio DI (direct injection) box between the
audio installation and the product.
Important! To ensure a reliable operation of the SAS100 many audioinstallations need to
be connected through a galvanic isolation. Streamit provides these devices.
Connecting the product to the mains power supply
Warning
!
•
Never use wet hands when putting the power adapter in the main. And also, never remove the power
adapter from the main with wet hands.
•
Do not cut or damage the cord of the power adapter. Also do not place heavy objects on the cord. This can
cause short-circuit, which can result in fire or electrical shocks.
•
Pulling the cord can damage the wire and/or isolation, which can case fire or electrical shocks.
•
The use of power adapters, which have not been recommended for this product, can result in overheating
and damage of the product. This can cause fire, electrical shocks and other dangers. Only use the supplied
power adapter.
•
Do not place the product in places with direct sunlight or high temperatures. This can result in the change of
the colors of the product and/or deforming of the casing. Ensure good ventilation around the power adapter
and the product.
•
Applying the product to situations with rapid changing temperatures can result in condensation (small
amount of water) on the inner and outer surface of the product. To ensure a long lifetime of the product, this
should be prevented as much as possible. Wait until the condensation has disappeared before you use the
product again.
Put the cord of the power adapter into the product and the mains power supply and press on the power button.
Connecting the product to the ethernet connector or ADSL router
Connect the product to the ethernet connector or ADSL router with the attached ethernet cable.
When everything is ok the green led of the Ethernet connector will be continuously on. The yellow led will flash
irregularly. If this doesn’t happen, please read in the chapter Troubleshooting to check what can be wrong.
