Page 14
Testing of the product with the built-in icecast server
Testing of the product with the build-in icecast server is a little bit more complicated. Please follow the instructions
below.
Execute the same steps as described in the previous paragraph:
-
Test whether the sound is available at the LINE-OUT connector of the product.
-
Install Winamp on your PC.
Start Winamp and enter the URL which is on the statuspage of the SAS100. You should hear sound now from the
speaker of your PC. If this is the case, the product is configured correctly.
However, the listeners are not on the local network, but on the internet. So this needs to be tested as well. This also
can be done with your PC.
Just enter instead of the local address of the stream the public address:
http://public ip-adres:8000/<mountpoint>
You should have received the public ip-address from your ADSL provider. If you cannot find it anymore, you can
determine it easily in the following way:
•
Start Internet Explorer from the PC on which you have installed Winamp.
•
Enter the following address:
http://www.streamit.eu/support/ip.php
.
•
You will see the public IP-address of your PC now.
Note that you can also find your external IP-address by browsing to the “Network” page of the SAS100 configuration.
After you enter this address in Winamp, you will hear your own audio stream.
Practice has learned that some ADSL modems do not allow you to access your ‘own’ external IP-
address. In this case it is necessary to execute this test with a dialup internet connection or from
another ADSL line.
After you enter this address on another PC which is connected to internet, you will hear the same audio.
If the SAS100 detects a problem with the internet connection, it will automatically try to correct the
problem. In this case you will hear an error beep each 10 seconds.
Switching off the product
After pressing on the power button, the product is switched off.
Important
Important
