Stratasys FDM 2000, Руководство пользователя

Страница: 114 / 148

Reference N-11
Notes
10MAY01
T
echnical Notes
Modeling with the T10 Tip (0.010-inch)
The T10 tip (0.010-inch) is designed for small, thin-walled, fine featured or
highly detailed parts. When used with the .007-inch slice increment, superior
surface is also achieved. The T10 tip is currently available on the FDM 2000/
3000/8000.
T10 Features
Features of the T10 tip include:
•
A .01-inch inside diameter and a .03-inch
outside diameter.
•
Use of a smaller nozzle outside diameter to
improve the modeling of small features.
•
An identification ring engraved into the tip
for easy identification.
•
.007 and .010 Def files
Setup Procedures Unique to the T10 Tip
•
For ABS material, set the model liquefier temperature at 290°.
•
Use the T10 tip for the model side and T12 for the support side.
•
Set the envelope temperature at 60°. Parts that are less than 1.5”sq. can run
with a 50° envelope.
•
Use of a run speed of 1 inch per second for all curves.
•
Use a contour and raster toolpath width range between .01 – .028 inches.
•
Run the calibration procedure whenever you change a tip. Proper calibra-
tion is very important, particularly in the Z-axis.
If necessary, refer to the
calibration procedures in the hardware section of your FDM manual.
•
Purge the model side liquefier prior to running a model (let the model side
load until the “load time fault” flashes on the key pad screen).
•
Run parts in the center of the foam when possible.
Single