DT3 CleanStation
DOC-01121 Rev. A
3-9
5.3 Powering On the DT3 CleanStation
To power-on the DT3 CleanStation:
1. Make sure that the power switch on the front panel is in the
Off
position.
Figure 2 Control panel and power switch
2. Plug the cleaning station into an electrical socket.
3. Make sure that the water level is no lower than 2.54 cm (one inch) from the
top of the tank.
4. Press the power switch to turn it on.
To start the cleaning cycle, see "Starting the Cleaning Cycle" on the next
page.
5.4 Using the Control Panel
You use the control panel to operate the DT3 CleanStation.
Figure 3 Control panel
Warning:
Do not change the factory default settings. Doing so might damage the DT3
CleanStation.You can change the cleaning time, if necessary.
Button
Function
Set
l
Press and release to display the water temperature.
l
Press and hold to display the low temperature point.
Infinity
l
Returns the display to
Home
.
l
Press and hold to set the cleaning time.
Arrows
l
Use to increase and decrease cleaning time.
l
With the display in the
Home
state, hold down the
Set
button and press the up/down arrows to adjust the time.
