23
Using the Icemaker & Water Dispenser
Before using the Icemaker / Water Dispenser
Water supply installation
•
Pressure of the cold water supplied to the automatic
icemaker is between 0.15 – 0.85Mpa.
•
The water tube should be of an appropriate length –
usually 12 metres – and should be free of bends after
being inserted into place. If the tube is too long then
pressure will be reduced, therefore reducing the
capacity of ice making.
•
We recommend that drinking water be used to create
ice as the appliance does not have a sterilizer in the
purifier. Always use potable / drinking water.
•
Keep the water tube clear of heat sources.
•
The water tube should be installed and tested by
authorised personnel.
•
When used for the first time, press and hold the cold
water button for one minute to prime the water supply.
Do not press the cold water button for any longer as
this may cause the valve to heat up.
Precautions
•
Never expose the water pipe to temperatures below
0˙C to avoid freezing.
•
Test the tubing for leaks by flushing the tube through
with water, until the water runs clear.
•
Once the temperature inside the freezer is at –15 C ice
production will begin – we recommend that you do not
store the first load of ice cubes.
•
After the appliance has been sited into the location of
your choice, make sure that the water tube is arranged
so it does not incur damage through bends and kinks
and is clear of any heat sources.
•
This appliance must be installed by a qualified appliance
installer.
•
Do not over use the icemaker. If you attempt to use
the ice cube button too often it will go into a shut down
mode. This is perfectly normal and requires you to wait
for one hour before attempting to re use it.
•
Do not use delicate or fragile glassware.
•
Do not touch the ice cube outlet with your hands, or
any implements to avoid injury or damage.
WARNING: Carbon
filters must be
changed every 6
months.
Spares may be
obtained from
Customer Care.
Installation instructions
for the connection kit
(to a potable / drinking
water supply) are
found inside the
crisper drawer in the
fridge. Please contact
Customer Care if any
parts are missing.
We recommend that
you use a qualified
engineer to connect
the appliance to the
water supply – and
that the instructions
are followed carefully.
!
i
Содержание ST980SXS
Страница 1: ......
Страница 11: ...13 About Your Appliance A B ...