AXS Strikemaster
Engineering Manual
AXS Strikemaster Programming and Operation Manual May 2013 Page 6 of 22
For more information visit
www.storm-interface.com
© Copyright Storm Interface. 2013. All rights reserved
Installation
Fixing Instructions (Please read carefully before attempting installation.)
Rear Casing
1. Select a suitable location with a sound flat surface. Using the case as a template, mark the position of the
four fixing holes (A) on the surface.
2. Drill and plug the fixing holes to suit fixing screws (E) as supplied.
3. Locate the anti-tamper switch actuator plate (F) on the rear face of the case in the position as shown. The
fixing screws (E) may be positioned in the case to assist in the accurate location of the plate.
4. Locate the thicker (6mm) sealing gasket (B) on the rear face of the case before positioning the case over
the fixing holes (A).
(Be sure to run the cable through the hole in the gasket prior to securing the case.)
5. Secure the case to the surface using the fixing screws (E) as supplied.
Keypad to Casing
6. When making the electrical connections to the connector block care should be taken not to
damage the thin sealing gasket (C) fixed to the front face of the rear case.
7. Fix the keypad to the rear case using the thread forming
security screws (D) as supplied. (Please ensure the nylon sealing
washers are located beneath the head of the security screws (D).
Please note a special bit is provided for tightening these
screws.
8. Check the installation to ensure gaskets are in
place and compressed evenly around the
perimeter of the case.
Note: On rough or uneven
surfaces it may be
necessary to apply a bead
of silicone sealant around
the inner face of the case at
the point where it meets the
mounting surface. Where this
method of sealing is
necessary the thicker
sealing gasket (B) must not be fitted
