Storch Kamine SIC 700 S, Руководство пользователя

Страница: 28 / 31

28
Gültig seit/Valid from/Valide: 09.10.2019
5. Plug the power adapter into the socket. This is followed by a 3x acoustic signal and
the diode on the central unit flashes green.
6. Make paring of mobile app with the regulator. See chapter 2.1.5 step 5 .
5.3 Heating with burn-off control
1. Open the loading door (LED indicator turns green and baffle on EAI opens on 40%).
2. Insert recommended amount of fuel (see note on oven model), light and close the
door.
Flap opens to 100% and remains unchanged in this position during the first
firing cycle . The colour of the LED display changes according to the temperature.
The first cycle lasts until the fuel burns out!
Burning cycle – the cycle starts with loading new load onto burning out remains of
previsous load and finishes with another load see page 18.
3. At the end of the first firing process (residual glow), a signal sounds and the LED
display flashes. This means that you have to refill now (you have 5 minutes to do this)
or burn-off control switches off. If you want to continue heating, this is the optimal
time to refuel and continue the heating process.
4. Slowly open the combustion chamber door (about 2 cm - for a few seconds) to create
a pressure balance between the room and the combustion chamber. LED indicator
lights up green, the air flap opens to 40%. Insert the desired, maximum recommended
fuel quantity.
5. Close the door. Air flap opens at 100% and burnup control begins to work in pre-
programmed mode. (ECO-SMART-TURBO
►
factory default = SMART). During the
burning process, the colors on the LED display change from green to yellow, red,
yellow and green again (same colors also on stork APP).
Do not add fuel during the
firing process.