1. Turn the cabinet power off as described in Section 7.1.
2. Determine the correct tape drive mounting locations and corresponding
cabinet rail mounting holes for the chassis rail assembly. Refer to the chapter
in this document pertaining to your specific cabinet configuration for this
information. The tape mounting hole specified for each position is the chassis
rail locating hole shown in Figure 7–5.
Figure 7–5 Left Position Chassis Rail Assembly Installation
UP
FRONT VERTICAL
CABINET RAIL
INNER
FLANGE
OUTER
FLANGE
FRONT
CHASSIS
RAIL
LOCATING
HOLE
CXO-3923A-MC
REAR VERTICAL
CABINET RAIL
ROUND
STANDOFF
(2 PLACES)
RAIL
BRACKET
WASHER, LOCK
10-32, INTERNAL
(6 PLACES)
SCREW, 10-32
HEX CAP
(6 PLACES)
CHASSIS
RAIL ASSEMBLY
U-NUT, 10-32
(4 PLACES)
U-NUT, 10-32
(2 PLACES)
INNER
FLANGE
REAR
CHASSIS
RAIL
LOCATING
HOLE
SCREW, 10-32
SEMS
(4 PLACES)
WARNING
Use care in supporting the chassis rail assembly. It is heavy and awkward
to position within the cabinet. If possible, use two persons to support and
position the chassis rail assembly. The chassis rail assembly may cause
personnel injury and equipment damage if dropped during installation.
7–8 Installing TZLX-Series Tape Drives
