rev030717
3
MOUNTING AND WIRING THE LIGHT
NOTE: RECOMMENDED INSTALLATION HEIGHT IS BETWEEN 6 ½ AND 10 FEET
This product is intended for use with the enclosed gasket and with a junction box marked
“
for use in wet locations
”
.
Before you begin make sure that your power is turned off at your circuit breaker box.
Do not rely on the switch power being turned off.
INSTALLATION
For easy installation, select an existing light operated by a wall switch for replacement.
1.
Install the cross bar (F) to the junction box and secure with the (2) cross bar screws (E).
If installing to a wall or building, pre-drill
holes and use appropriate plugs/anchors. Once your holes are drilled you can install the cross bar to the surface using the two cross
bar screws (E).
F
2.
On the cross bar locate
“
GND
”
, attach the ground wire with the grounding Screw (G) to the cross bar (F).
3.
Using wire nuts (not included) to connect the ground wire to the house ground wire (typically copper).
For proper connection, place
wire nut over wires and twist clockwise until tight.
4.
Install the gasket (H).
