rev030717
4
5.
Connect supply wires with wire nuts (not included) as shown in main diagram on page 3.
Black supply wire connects to the Black power supply wire (Live)
White product wire connects to the White supply wire (Neutral)
6.
Install the light fixture (B) to the quick connect (D).
Use silicon sealant (not included) around the perimeter of the light to seal for
7.
Screw in the quick connect screw (C) to hold the fixture in place.
8.
Turn on your electricity after the install has been completed.
9.
If wired to a power switch, turn on the power switch. (If power switch is not on, the light will not cycle on or off)
ADJUSTING YOUR LIGHT HEADS
The light head can be adjusted by turning the individual light heads to desired position. You can also adjust your light heads up and down to
your desired position.
SETTING THE MOTION SENSOR
(Max Detection Range: 7
0’
/Max Detection Angle: 180°)
TIME SETTING
The ‘On Time’ setting
controls the time span of how long your security light will remain on when motion is detected. Slide the switch to the
amount of time you would like the light to stay on. (See illustration). Control settings are located on the bottom side of the motion detector.
MANUAL OVERRIDE
This light has a manual override mode, so the light can stay on at all times. The light will need to be wired to a power switch to use the manual
override mode.
To change to manual override mode, turn the power switch ON/OFF/ON within 2 seconds. The light is now in manual override mode and will
stay on.
To change the light back to the standard setting to detect motion, turn the power switch off and leave off for 20 seconds. The unit will
complete a warmup cycle and resume normal operation for motion detection depending on the motion setting the light has been set to.
