Stoelting M202A, Руководство оператора

Страница: 6 / 35

Page 3
A. Initial Start
1. Make sure the refrigeration
and beater switches on the
front of the machine are
turned “OFF” and the beater
key is removed.
B. Flow Control Valve Assem-
bly and Insertion
1. Place the white plastic flow valve in
the hopper pan drain hole. Tapered
portion of the tube to be inserted in
the drain tube hole.
2. Place the flow valve arm on the
square flow valve drive which
is located at the front of the
hopper pan.
3. Place one end of the flow control rod
in the small hole located on the flow
valve and place the other end of the
rod in the small hole on the flow valve
arm.
4. To adjust the flow control, turn the
flow control knob clockwise to in-
crease the flow and turn counter
clockwise to decrease the flow.
C. Beater Shaft and Blade As-
sembly
1. Coat the rear gasket with a small amount of Petrol
Gel. Place the rear gasket on the beater shaft. The
gasket should be placed over the hex cut end and
pushed over the round portion of the shaft until it
bumps against the square of the shaft. Put a small
amount of Hex Drive Anti Seize on the hex end of
the beater shaft.
2. Starting on the end
of the beater shaft
with the square tip,
place a metal
spring (arched up-
ward) over the two
pins closest to the
end. Place a blade
on top of the spring.
3. With the spring and
blade in place, slide
the beater shaft into
the barrel several
inches with the
blade facing down.
4. Put a spring and
blade on the next
set of pins. Push
the beater shaft fur-
ther into the barrel
just far enough to
hold the blade in
place on the shaft.
As you push, turn
the beater shaft so
the next set of pins
is facing up. You will have to squeeze the blade
and spring against the beater shaft in order to push
the shaft into the barrel.
5. Continue adding springs and blades to the beater
shaft until all 12 blades are installed. It may get
more difficult to push the beater shaft into the bar-
rel as you add springs and blades.
6. Using the beater shaft wrench, push and turn the
beater shaft until it engages the drive coupling in
the back of the machine. When the beater shaft en-
gages, it will move approximately one inch further
into the barrel. It will not be able to move back any
further. At this point, the entire shaft assembly will
be inside the barrel.
Assembly/Sanitizing