Stoelting E131G, Руководство по обслуживанию

Страница: 47 / 80

39
5.14 TOUCH PAD SWITCH MODULE
ASSEMBLY
1. Position the circuit board on the new module and
secure with the four screws.
2. Insert the ribbon into the connector and close the
hinged portion of the connector.
CAUTION
THE CUTOUTS IN THE RIBBON MUST LINE
UP WITH THE PRONGS ON THE HINGED
PORTION OF THE CONNECTOR BEFORE
CLOSING.
3. Place the switch module into the housing top first,
then the bottom.
4. Replace the retaining screw using a 5/64” Allen
wrench.
5.15 SENSOR
The sensor monitors refrigerant gas temperature exiting
the evaporator. Refer to page 28 for values.
5.16 SENSOR REMOVAL
1. Loosen the two (2) Phillips head screws and remove
the decorative header panel.
NOTE
To access the sensor, remove the side panel on
the failed side.
2. Remove the Phillips head screw from the side panel
and pull down and out. If the failure is on the right
side, the back panel and side electrical box must be
removed. To remove the back panel, remove the two
(2) Phillips head screws, then pull down and out. To
remove the electrical box, remove the two (2) Phillips
head screws from the cover and remove the cover.
Remove the two (2) fan wires from the terminal block.
Disconnect the two (2) red molex connectors from
the back of the electrical box (Figure 59). Remove
the four (4) Phillips head screws that hold the
electrical box to the frame and remove through the
rear of the freezer.
3. Remove the two (2) screws from the cover plate and
pry off (Figure 60).
Figure 59. Electrical Box Removal
4. Use a one (1) inch putty knife to cut the foam
installation by gently pushing straight in (Figure 61).
Figure 60. Cover Plate Removal
Figure 61. Foam Insulation Removal