Page 5 of 9
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Power Harness Installation
24.
Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove it. Fig.
14
25.
Using a razor knife make a small cut in the center of the grommet. Pass the end of the wires with the
small terminal on the ends through the grommet and pull the grommet up to the point where the plastic
sheathing starts. Fig. 15
26.
Run the wires through the grommet hole in the fire wall and reinstall the grommet.
27.
Run the wires along the top of the fire wall toward the battery and secure with wire ties.
28.
Remove the top of the fuse cover and using a 13mm socket and ratchet loosen and remove the nut
on the positive battery accessory lug. Fig. 16
29.
Connect the ring terminals of the power harnesses to the lug and retighten the nut. Torque to 10Nm.
30.
Using a panel removal tool remove the four plastic retainers (three in front door opening and one in rear
door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 17
Fig. 13
