Page 2 of 9
Fig. 1
Fig. 2
Radio Removal
1. Disconnect the negative battery terminal before you begin.
2. Using a panel removal tool, pry up on the plastic trim panel located above the radio. Make sure to pry
on the side of the panel closest to the window. Fig. 1
3. Using a panel removal tool pry loose the top edge of the panel below the HVAC controls. Fig. 2
4. Remove the four screws securing the radio trim bezel. There are two at the top and two at the bottom.
Fig. 3
5. Starting at the top and working your way down pull out on the trim bezel to release the fasteners
securing it. Once the bezel is completely detached from the dash it is not necessary to disconnect
any of the wiring or the HVAC linkage. Simply allow the bezel to rest on the console to allow access to
the screws securing the radio. Fig. 4
T-TAP x2
FUSE
WIRE T IES x6
SUBWOOFER ASSEMBLY
200 WATT AMP
POWER HARNESS
OVERLAY HARNESS
