Page 3 of 9
Fig. 5
Fig. 6
Fig. 3
Fig. 4
Fig. 7
Fig. 8
6. Remove the screws securing the radio and pull the radio from the dash and disconnect the wiring.
Disconnect the antenna cable by pulling the locking antenna connector away from the radio. Caution:
Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector
could damage the cable or radio.
Amp Installation
7. Gently pull out on the panel just below the steering column, rotate down and remove. Fig. 5
8. Find the small panel just below the one you just removed and pull to remove it as well. Fig. 6
9. Remove the two bolts securing the metal plate below the steering column. Fig. 7
10.
Install the amp bracket in between the dash frame rails and line up the holes in the bracket with the
holes. Install the supplied 10mm bolt in the lower middle hole but do not tighten.
11.
Temporarily install the two bolts that retain the metal plate in order to stabilize the amp bracket while
the amp is mounted. Fig. 8
