Still FM-X 10 N, Оригинальное руководство пользователя

Страница: 102 / 380

Switching on
Switching on the key switch
WARNING
Before switching on the key switch, all tests prior to
commissioning must be performed without any de-
fects being detected.
–
Carry out checks prior to commissioning (refer to
the chapter entitled "Checks and tasks to be car-
ried out prior to commissioning").
–
Do not operate the truck if defects have been
identified.
–
If defects are detected, notify the authorised serv-
ice centre.
–
Insert switch key (1) into the key switch and
turn to position "I".
This initiates a self-test. All symbols on the
display and operating unit are displayed briefly
until the truck controllers have started up com-
pletely.
When the truck is switched on, the fork car-
riage and the reach carriage must initially be
in the basic position. In the basic position, the
fork carriage is fully lowered, and the reach
carriage is fully retracted. This ensures that
the electronic support systems which prevent
the truck from tipping over with a raised load
are recalibrated.
–
If the lifting forks and the reach carriage are
not in the basic position when the truck is
switched on, fully lower the load once and
fully retract the reach carriage.
NOTE
The switch key, FleetManager card (variant),
FleetManager transponder chip (variant) or
FleetManager PIN code (variant) must not be
passed to others unless explicit instructions to
this effect have been given.
0
I
1

Operating
4
Switching on
90 50988078001 EN - 11/2021 - 10