14 SERVICING AND MAINTENANCE
54
Service personnel
NOTE!
Servicing and maintenance must be carried out by
specially appointed and trained personnel with a good
working knowledge of the function and maintenance
of the truck.
To obtain the best results from your truck investment, we advise
you to contact your service organisation and take out a service
agreement for continuous maintenance.
Safety instructions for maintenance
Working at height
Comply with local safety instructions when working at height.
Precautionary measures during repair
Extreme importance must be placed on precautionary
measures to avoid accidents during all work on the truck.
•
WARNING!
The battery plug should be pulled out before
working on the truck.
•
Ensure that the drive wheel is off the ground before trouble
shooting. Secure the truck with blocks.
•
To prevent injuries caused by crushing the battery plug
should always be removed when working on and around
the mast and hydraulic unit.
•
When dismantling parts of the hydraulic system the system
must not be pressurised, e.g. the pump motor is shut off
and the forks are down.
•
The battery should always be protected during grinding
work.
•
When changing a fuse the controllers must be thoroughly
discharged. (Remove the battery plug and wait for two
minutes before fuses are changed, otherwise there a risk
of arcing.)
•
Great caution must be observed when removing gas
springs.
Maintenance intervals
Recommended replacements
NOTE!
To ensure correct operation, use only original spare
parts.
•
The hydraulic oil filter and air filter should be changed
annually or every 1,000 hours of operation.
•
The hydraulic oil should be changed every three years or
every 3,000 hours of operation.
•
Environmental/Food classified hydraulic oil must be
changed annually or every 1,000 hours of operation.
Instruction Handbook UFW — D008453, B, GBR, ForTranslation
