STIHLER ELECTRONIC ASTOPAD, Инструкция по эксплуатации

Страница: 48 / 59

ASTOPAD
®
Instructions for Use
48
Operating
state
Display
“Start”
LED
Output
A or B
“Alarm”
LED
“Standby”
LED
Acous-
tic
alarm
signal
Possible
reasons
Green Yellow Blue
Heating mode
Actual temperature
Set temperature
Warm-up phase
Actual temperature
Set temperature
A5
No applied part
connected, or
defective sensor in
the applied part
Actual temperature
Set temperature
A6
No applied part
connected, or
defective heating
conductor in the
applied part
OFF Output not started
L
Set temperature
temperature of the
applied part
< 20.0 °C
Actual temperature
Set temperature
Cooling phase
Actual temperature
Set temperature
Defective or
incorrect battery
Standby
Increase/
decrease set
temperature
Actual temperature
Set temperature
New set tempera-
ture not confirmed
Mode
Switching off
an output
OFF -
Actual temperature
Set temperature
Only one output
was started; device
is in self-test
Switching off
the control
unit
OFF See Standby mode
Off mode OFF
Mains plug pulled
out
Off mode
OFF
The “Standby”
button has been
pressed for more
than 3 sec. (only
for
battery-operated
equipment)
= LED off = LED on = LED flashes
11
6 10 9