Stieber Clutch
Page 13/21
M1016E_0
Assembly and maintenance manual
The level should be up to a maximum of 10 mm to an inside diameter of the outer race.
6.2.2 Operation with grease lubrication
NOTE
Excessive lubrication may negatively affect the one-way clutch
functionality! Note the required grease quantities!
NOTE
Unsuitable lubricants can negatively affect the one-way clutch func-
tionality! Only use greases approved by Stieber!
Select only lubricating greases complying with product catalogue/ Stieber WN900.
Procedural steps for greasing:
Place the one-way clutch facing upward the label "FREE" on an assembly table
Remove the cable clip
Lift the inner race (2) including the cage (8) out of the outer race (1). Use
appropriate lifting gear at the threaded hole of the inner race for this
Grease the outer track with a layer thickness of approx. 1 mm
o
Use grease of NLGI class 000 to 2 with a maximum base oil viscosity
of 42 mm2/s
Secure (see Fig. 5 and 6) the clamp bodies in lift-off position (against the spring
force) using an O-ring / cable connector as an assembly aid
Insert the inner race (2) with cage (8) into the outer race (1) until half of the clamp
body is covered
NOTE
The assembly aid (O-ring / cable connector) must be completely
removed. Non-observance of this note can cause functional
impairment and even failure.
Remove the assembly aid (O-ring / cable connector) completely and lower the inner
race and cage completely.
Check overrunning. The one-way clutch must be able to be turned easily in the
overrun direction of rotation.
