STIEBEL ELTRON Stratos Brahma 3.0, Инструкция по эксплуатации, установке и послепродажному обслуживанию

Страница: 24 / 36

24 CUSTOMER SERVICE
The appliance is manufactured for use with natural gas.
If the appliance is converted for use with ULPG, the sup-
plied kit must be used and the work only performed by
an authorised qualified person.
Natural gas; nominal & minimum pressure regulation.
- Open the gas tap put the electrical plug under the
appliance then push the start button and put to the max
power.
Burner pressure
- Loosen the pressure screw (1) connect the manometer
and verify the pressure value is between 1.7kPa/2.5kPa
(like indicated in the table) then close the screw after
that the manometer tube is pulled away.
- Loosen the pressure screw (2) connect the manometer
verified the nominal and minimum pressure values are
as specified in the table.
Nominal pressure
With the appliance operating at a high setting loosen
the outlet pressure screw (2) then connect the mano-
meter and verify that the nominal pressure values are as
specified in the table (test point pressure). At comple-
tion take away the manometer and fasten the screw.
Regulation ULPG 2.75kPa. Minimum and nominal
pressure.
- Open the gas taps put the electrical plug under the
appliance then push the start button and put to the max
power.
Burner pressure
- Loosen the pressure screw (1) connect the manometer
and verify the pressure supply for ULPG is 2.75kPa then
close the screw. In the case that the net pressure is low,
operate on the low-pressure regulator that is put on the
Gas tank.
- Verified that the establishment ULPG vaporization
capacity is sufficient.
Nominal pressure
With the appliance operating at a high setting loosen
the outlet pressure screw (2) then connect the mano-
meter and verify that the nominal pressure values are as
specified in the table (Test Point Pressure). At comple-
tion, take away the manometer and fasten the screw.
5
4
2
1
REGULATION