STIEBEL ELTRON Stratos Brahma 3.0, Инструкция по эксплуатации, установке и послепродажному обслуживанию

Страница: 20 / 36

20 INSTALLER
Check on the technical label that is on the heat exchan-
ger cover, for the kind of gas that the appliance uses.
Use the proper gas tubes and pipe fitting in accordance
with AS/NZS 5601.1. The etching under the appliance is
a 3/8” M UNI ISO 7/1.
After the gas connection is done, do the first seal
tests.
GAS CONNECTION
The appliance must be installed by an authorised per-
son. Upon completing the installation, such companies
or persons must issue a declaration of installation con-
formity in accordance with applicable national and local
laws (see art. 17 of law no. 46/90) and the instructions
provided by the Manufacturer in the installer’s booklet
attached to the product.
The appliances are fully wired in the factory and comple-
te with plug for connection to the power mains.
Only a HAR H05 RRF type power cable need be made
with MIN cross section of 1 mm, using, for connection
to the appliance, the socket provided and making an
EARTH connection that is 2 cm longer than the PHASE
and NEUTRAL leads.
Connect the other end of the cable to a socket or omni-
polar switch, in conformity with CEI standards, con-
nected to an effective EARTH system.
A proper earth connection is mandatory.
The manufacturer of the appliance cannot be held liable
for any damage caused by lack of proper earth connec-
tion.
For jobs of an electrical nature, always refer to the dia-
gram attached to this booklet.
Fit a disconnection device from the power mains upstre-
am of the power cable (omnipolar switch or plug) such as
to ensure a contact opening of at least 3 mm.
Unsheath the EARTH lead so this is at least 2 cm
longer than the other two leads.
Never use gas and/or water pipes to earth the
appliance.
POWER CONNECTIONS