STIEBEL ELTRON Stratos Brahma 3.0, Инструкция по эксплуатации, установке и послепродажному обслуживанию

Страница: 15 / 36

FITTING THE TEMPLATE, UNION AND PIPES
To determine the position of the APPLIANCE and of the
support template (3), use the paper template
(4) provided:
- level and mark the holes (1, 2), then remove the paper
template from the wall;
- make the holes (2) for fastening the template to the
wall;
- make the centring hole (1), through the entire wall
thickness;
- make the hole for the flue pipes using the centring
hole (1);
Ø 65 mm hole for Ø 32 mm pipes or Ø 110 mm hole for
Ø 54 mm pipes.
- remove the plate (5);
- fit the adapter union unit (6) on the template, using the
screws provided;
- cut the pipes to the thickness of the wall adding 25
mm, then eliminate the excess parts.
The cut must be perpendicular to the pipe axis,
being very careful not to deform these. After cut-
ting, carefully remove any burrs.
To make it easier to fit pipes with O-rings, use silicone
grease or a soapy solution and make sure the O-rings do
not exit from their seats.
In the event of the spacer support being used, the tem-
plate + unit + pipes must be fastened directly on the
support and the pipes must be fitted in the slots provi-
ded on the support.
- fit and fasten the pipes (7) on the unit (6);
- level the te unit + pipes;
- insulate the exhaust pipe (8) and fit the pipes in the
hole in the wall;
Before fastening the pipes, only for lengths greater
than 50cm, insulate the fume exhaust using mate-
rial resistant to temperatures above 200 °C (e.g.
HT/-Armaflex).
- fasten the te unit + pipes on the wall using
the screw anchors provided (2);
Use the screw anchors most suitable for sustaining
the weight and suitable for the material of which
the wall is made and to which it is being fastened.
8
6
3
7
2
2
5
6
3
2
2
3
2
2
1
4
15 INSTALLER