STIEBEL ELTRON Stratos Brahma 3.0, Инструкция по эксплуатации, установке и послепродажному обслуживанию

Страница: 21 / 36

The appliance is manufactured and preset for natural
gas and regulated in factory.
First things to do before you start the appliance check:
- If the appliance is preset for the right gas
- The gas connection is correctly done and the gas
switch is turned on.
- The electrical connections are properly done.
Ensure the correct electrical connection
During the first start, could be emissions of vapors and
odors annoying non dangerous. To avoid these incon-
veniences, it is recommended to run the unit at full power
for several hours and ventilate the room.
For greater comfort in the heated environment, we advi-
se using the humidifier tray (1) encased in the casing.
Do not fill the tray to the top to prevent water
overflowing with consequent damage to or mal-
function of the appliance.
Only fill the tray with water. Avoid all other liquids
that could damage the tray or cause appliance
malfunctions.
After performing all the preparation operations for initial
start-up, to start the appliance:
- make sure the gas tap is open;
- fit the plug in the socket on the appliance;
- move the master switch (if fitted) to “on” or fit the
power plug in the wall socket;
- press the On/Off key (see User section) to switch on the
appliance;
- set the room thermostat at a high value to reduce hea-
ting time;
After startup, the appliance runs until it reaches the set
room temperature.
In case of malfunctions in startup procedure or ope-
ration, the appliance STOPS and the relevant unblock
signal lights up on the display. Reset the appliance by
keeping the unblock button pressed. Wait until the
startup procedure is completed and the operation signal
lights up.
- When the appliance is running, set the clock and the
timer for automatic operation (see User section).
FIRST SERVICE START
PRELIMINARY OPERATIONS
1
21 CUSTOMER SERVICE