①
②
③
④
⑥
⑤
⑦
型紙
ＬＨ
ＲＨ
BUMPER
BUMPER
REAR SIDE UNDER S
POILER
//
//
//
//
//
//
/
//
/
//
//
//
/
//
/
//
//
///
///
///
///
/
//
//
/
//
//
//
//
//
//
//
//
/
//
//
//
//
//
//
//
//
//
//
//
//
//
//
//
//
/
//
/
//
//
//
//
/
//
//
//
/
//
//
/
//
//
//
//
//
//
/
//
/
//
//
//
//
//
//
/
//
//
////////
///
//
//
//
//
//
//
//
//
/
//
//
//
/
//
//
/
//
//
//
//
//
//
//
//
//
//
//
//
/
/
//
/
//
//
//
//
/
//
//
/
//
//
//
//
//
//
/
REAR SIDE UNDER
SPOILER
φ12
㎜
φ12
㎜
Components
Tools
-2-
Before Work
①
②
RH:1 /LH:1
No.
Qty
Part Name
STI Rear Side Under Spoiler
2
- Make sure to check the components below before installation.
- When installing this product, park the car on a level ground and apply the parking brake.
- When installing this product, be sure not to damage the car body.
- Before installing this product, wipe off any dirt or oil film from the Rear bumper attachment surface
with a soft waste cloth dampened in a neutral detergent. Then, let it dry completely before work.
- The adhesive strength is weakened significantly when the temperature is 15
℃
or lower.In this case,
use a dryer to warm the double-sided tape before attachment.
(Do not warm up excessively as doing so may result in deformation.)
- Be extremely careful not to let this product get wet by washing, etc. for 24 hours after attaching it.
Dosing so may cause the product to come off.
- To protect yourself from burns, make sure to stop the engine and let it cool completely before work
- When jacking up the vehicle, be sure to keep the ground level and a hard place where the jack does
not bite, and be sure to support it with a rigid rack before carrying out the work.
③
④
⑤
Clip(Small)
Pattern paper RH/LH (P7)
4
4
φ3mm φ6mm φ9.5mm φ12mm
Clip(Large)
2
⑥
⑦
Washer
Wellnut
Bolt
2
1
8mm
