LH
Fr
UP
Fr
LH
UP
3mm
→
6mm
→
12mm
-3-
LH
Fr
UP
Fr
LH
UP
LH
Fr
UP
3
2
1
1. Drill holes in the Rear Bumper
( The RH side also performs the same work. )
Masking tape
Rear Bumper
Rear Bumper
Rear Bumper
Rear Bumper
Rear Bumper
Bottom view LH side
Bottom view LH side
LH view
Bottom view LH side
Fender garnish
Remove the
Vehicle clip
Along the bumper shape
Matte range
！
Advice
After drilling, remove the burrs around
the hole.
Make a 12mm hole only in the bumper,
being careful not to penetrate the parts
behind the bumper.
！
Advice
(1) Refer to the service manual, remove the
Fender garnish, and remove the Vehicle
screw.
Next, remove the two vehicle clips.
※
Reuse Vehicle screw.
※
Do not reuse Vehicle clip.
(4) Refer to the service manual,restore the
Fender garnish to the Rear Bumper.
(2) As shown in Fig. 2, determine the position
of the pattern according to the P.L.(step)
and fix it with masking tape.
Mark the center of the hole in the
⑦
pattern
paper LH with a marking needle.
(3) As shown in Fig.3, spread the rear bumper
outward and insert the waste cloth.
Make pilot holes at the marking positions
in the order of 3 mm and 6 mm, and finally
make a 12 mm hole.
！
Advice
Drill
cloth adhesive tape
5mm
During drilling, put a cloth adhesive tape
as a stopper around the drill blade about
5mm from its tip in order to prevent
damages to the
Rear Bumper
.
Vehicle screw
Vehicle clip
⑦
Pattern paper LH
Fit to P.L.(step)
P.L.(step)
⑦
Pattern paper LH
Spread
the outside
Cover side lower
Cloth, etc.
Spread
the outside
