-6-
ｃ
（1）
（2）
（3）
（4）
△
Newly created document
Revised contents
Details of the work
Date
11 / Jun / 2021
00
Reference tightening torque 1.0N
･
m
(0.1kgf
・
m)
This is the end of the work.
(7) Fully tighten the bottom
⑥
bolt with a
ratchet wrench 8 mm.
！
Advice
If it is difficult to remove the release paper,
slowly pull it out with needle-nose pliers.
(5) Compare the arrow C and decide the
mounting position so that the left and right
sides look even.
The double-sided tape is crimped while
slowly pulling out the release paper in the
order of (1) to (4).
11
12
・
By installing this product, it is up to 32mm lower than the rear bumper.
・
Because it is easy to come into contact with curbs, ring clasps, steps, etc.
Be careful not to touch it while driving or parking.
If it comes in contact with it, it may be scratched, deformed, damaged or dropped, and the spoiler
may be damaged accordingly.
・
In the case of slight contact, you may not notice the contact, so be sure to perform a pre-operation
inspection and check the area around the mounting part in particular.
・
Also, running in snow or ruts may damage the spoiler, deform it, drop it off, or damage the vehicle.
Damage caused by these or equivalent external forces is not covered by the warranty.
To customers
(6) The force that the car shakes with the
double-sided tape adhesive part
Crimping with.
・
The back side of this product is not painted. It may vary depending on the product.
・
We do not accept warranty repairs such as scratches, discoloration of paint, and peeling that occur
during use.
(8) Finally, check the floating and tilt of the
mounting part, No missing clips or bolts or
forgetting to tighten Please check if it is.
