Stewart Filmscreen –
Balón
11
LED KIT INSTALLATION GUIDE
Use the following steps to connect the LED kit to the Balón Series.
Note: This step should always precede screen material attachment.
1.
Start at either bottom corner of the back of the Balón frame, depending on which side you would
like your power supply to run on (see Figure 5).
Figure 5: Start and end of LED strip attachment
2.
Begin at the LED rail and start laying down the adhesive side of the LED strip, about 1/4” away from
the edge (see Figure 6).
Figure 6: Cross section of Balón frame indicating LED rail
LED rail
¼” from back edge
