2.
If you didn’t complete this step in the sub assembly section, now is a good time to install the servo mounting
block parts SR2a / SR2b and SR2c ply doublers. Install to one of the fuselage sides wicking thin CA into joints.
Be careful not to interfere with the notching for F12.
3.
Lay fuselage side on a flat surface and gently work former F2 and SR1 servo tray into position. Repeat for the
opposite side. Tack glue F2 into position by wicking a small drop of CA onto a tab joint on each side. Only
apply enough glue to tack the assembly together, we still want the parts to have the ability to shift. DO NOT
apply glue to SR1 joints.
4.
Key former FT1 to fuselage sides and F2. Invert on flat work surface and tack glue FT1 along tab and notch
joints at fuselage sides.
© 2004 Stevens AeroModel.
12
