Fuselage
(continued)
24.
Fit and bond hardwood rails, parts F22 and F23 (sheet 08/08, 3/32 in. basswood) to the
notches along the edges of the wing saddle.
25.
Sand the
front
and
rear
of the wing pylon to a rounded shape. Set the completed pylon
assembly aside until required in final assembly.
Pro Builder Tip:
We used a small piece of sandpaper wrapped around a 1/4 in. dowel to
help sand the front and rear of the wing pylon.
Wing
Wing parts are designated with the letter “W” followed by a number. Parts have been numbered so that
the wing assembly follows a sequential order: W1 to W22.
26.
Assemble the wing spar by fitting together parts W1a (sheet 04/08, 3/32 in. balsa) and two
parts W1b (sheet 04/08, 3/32 in. balsa). Bond with CA.
27.
Fit rib W2 (sheet 05/08, 3/32 in. balsa) to the
center
notch in the assembled wing spar.
Refer to the
Top View
-
Wing
drawing on the plan set for placement.
28.
Fit the two ribs, W3 (sheet 05/08, 3/32 in. balsa) to the spar, one on each side of, and flush
against the center rib W2.
29.
Build the
right
wing inner panel first:
Fit rib W4 (sheet 01/08, 1/16 in. balsa) to the
middle
notch on the wing spar W1. Refer to the
Top View
-
Wing
drawing on the plan set for
placement.
30.
Fit and “tack glue” rib W5 (sheet 05/08, 3/32 in. balsa) to the tip of W1. Ensure that it rests
flush against the slightly-angled end of the wing spar W1. Refer to the
Top View
-
Wing
drawing on the plan set for placement.
Build Instructions
Playmite 75
- Build Instructions © 2014 Stevens AeroModel, all rights reserved.
!
Page 14
□
□
□ □
□ □
□
□
□