Radio and Control Rigging Cont.
Center servo electronically. Adjust control
wire at right horn, removing slack, and crimp
to final length.
Adjust control wire at left horn. Snug wire
until rubber band is just under tension.
Turn on radio and test rudder movement.
Rubber band should have just enough
tension to return rudder to full left position
reliably.
Do not over tension rubber band,
as this may stress the servo.
When
satisfied that rubber band has proper tension,
crimp wire to final length.
Mount 7.4V two cell 120mAh battery [HP-
LG325-0120-2s] below the gear box with
sticky Velcro (not provided).
Congratulations your
eHopper
™ is finished!
Mount wing with provided nylon bolt and
secure struts.
Bend tail skid per plan, fit to hole in rudder
horn, and bond with medium CA.
eHopper
TM
© 2009 Stevens AeroModel all rights reserved.
Page 34 of 36
