Radio and Control Rigging Cont.
Rudder Rigging:
Cut two 18 in lengths of
rigging wire. Crimp end of one wire to the
left-hand servo in the same manner as done
previously with the tail/seat rigging.
Route control wire above tail rigging and
through right side of rudder horn. Center
rudder and snug wire. Do not crimp yet.
Attach second wire to left side of control horn.
Snug wire but do not crimp.
Attach control wire to supplied connector
[SIGSH445], snug up and crimp.
Loop one rubber band around left axle as
shown. Attach connector to rubber band.
Fix rudder in center position by trapping
between two sticks taped together.
eHopper
TM
© 2009 Stevens AeroModel all rights reserved.
Page 33 of 36
