12
Prior to reassembling the electronic unit and the battery, make sure that the o-ring is still
in its groove and not damaged. Replace it with a new one if needed. Clean and lubricate
it with silicone grease.
Important:
Make sure that the faucet is not wet when reassembling the electronic unit.
Carefully push the sensor into the
faucet’s body to gain access to the
battery and pull it out of the body together
with the battery.
Replace the used battery with a new 9V
battery. A lithium battery is recommended.
Release the Allen screw to carefully
remove the faucet’s body.
Disconnect the connector from the elec-
tronic unit’s connector.
If your model is Swan 1000
:
Release the handle-set-screw to
remove the mixing handle. Release the
Allen screw to carefully remove the axis
assembly by pulling it out.
Turn off the shut off valve (angle valve).
If your model is Swan 1010
, go to
1
2
When the battery weakens, the red indicator light will blink at a constant rate. The battery
must be replaced within two weeks.
BATTERY REPLACEMENT
To replace the battery at Swan 1010 \ Swan 1000 models:
3
4
5
3
SCREW
CONNECTORS