12
Step 1 – Installing the flush valve and connecting the water supply
1) Shut off the water supply.
2) Cut an adequate opening in the wall for the dimensions of
the box and the sleeve (not supplied).
3) Insert the electronic flush valve’s box through the opening.
4) Connect the flush valve inlet to the water supply.
5) Connect the flush valve outlet nipple to the pipe leading to
the W.C.’s inlet.
6) Turn on the water supply. Make sure there is no water
leakage.
7) Assemble the temporary protective cover to protect the flush valve.
Step 2 – Connecting the power source
I N S TA L L AT I O N
NARA 2032 PE
1) Once the electricity, plumbing and tiles works are finished,
replace the temporary protective cover with the plastic seat.
Adjust it using the four screws provided.
2) Connect the following connectors coming from
the electronic unit:
a. Connect the blue cable connector to the blue
cable connector coming out from the piezo
button.
b. Connect the electronic unit connector that
leads to the solenoid valve to the solenoid valve
connector.
3) Assemble the panel to the cover seat and tighten it with
the bottom screw.
