15
S E T T I N G S ADJUSTMENT
Adjusting the sensor range with the remote control
This flush valve was supplied with Stern’s new Self Adjusting Sensor. The ideal
detection range for the specific location will be set automatically.
TEMPORARY OFF FUNCTION
D E L AY I N T I M E
DETECTION RANGE
DELAY OUT TIME
R E S E T
E N T R A N C E T O T H E
S E L F A D J U S T M E N T M O D E
SHORT FLOW TIME
FULL FLOW TIME
DETECTION RANGE: Only if necessary
, use the remote control to
adjust the sensor range as follows:
Hold the remote control straight in front of the sensor in a distance
of about 8-10” (20-25cm). Choose the function RANGE by pressing
once at the range function button. After pressing this function
button, a quick flashing of the red light at the front of the sensor
will occur. At this stage, you can increase or decrease the sensor
range by pressing the (+) or the (-) buttons, every push will increase
or decrease one level.
Note:
Once you have changed the detection range with the remote control,
this distance will be remembered by the sensor, even if the power source is
disconnected. To get back to the self adjustment mode, use the ADJ button only.
