CLRS Series RS485 Closed Loop Stepper Drive User Manual
Safety Precautions
Overall Notes
Precautions for Storage and Transportation
Do not remove the housing with the drive powered on. Cables.
Connectors and optional equipment.
Please disconnect the power supply for at least 2 minutes and make
sure the power indicator is off before wiring and checking. Even if the
power is disconnected, voltage may remain inside the drive. Therefore,
do not touch the power terminals while the power indicator is on.
Please use the power supply specifications (number of phases.) that
match the product. Voltage. Frequency. AC/DC).
Be sure to connect the ground terminal of the driver (mounting surface)
and motor to the ground pole.
Do not damage or drag the cable, do not overstress the cable, do not
hang heavy objects on the cable, or get caught in the cabinet door.
Please do not disassemble the product yourself. Repair or modification.
When the machine is connected to the machine and starts to operate,
make sure that the machine is ready for emergency stop.
Do not touch the inside of the drive.
The heat sink of the driver may be hot when the power is on or when
the power is just cut off. The motor, etc. may be in a high temperature.
Take safety measures such as installing a cover to prevent accidental
touching by hands and parts (cables, etc.).
Use double-insulated or reinforced insulation for control power.
Do not use in places where water can be splashed. Corrosive
environments. Do not use the product in the vicinity of flammable gases
and combustible materials.
Do not use damaged. Drivers and motors with missing parts.
Please set up an emergency stop circu
it externally to ensure that the power
can be cut off and the operation can be stopped immediately in case of
an abnormality.
If the product is used under poor power conditions, install protection
equipment (AC reactor, etc.) to ensure that the input power is supplied
within the specified voltage variation range.
Please use a noise filter to reduce the influence of electromagnetic
interference.
The driver and motor should be used in the specified combination.
Please follow the Commands on the packaging for storage and do not
overload the product.
Please place this product in the following environment:
→No direct sunlight in the place.
→Ambient temperature does not exceed the product specification.
→Humidity does not exceed product specifications. Without
condensation.
→No corrosive gases. Place of flammable gas.
→Dust. Dust. The place where there is less salt and metal powder.
→No water. Oil. The place where the splash of medicine, etc. occurs.
→Vibration or shock does not exceed product specifications.
→No equipment generating strong magnetic fields in the vicinity.
