Stel THOR 41K PFC, Инструкция по эксплуатации

Страница: 18 / 28

6932200010
18
excessive lengths may cause problems during the
cutting process.
A pressure switch set at 3 bar inhibits operation
when the pressure at output of the reducer is
insufficient to guarantee operation.
LIFTING
WARNING :
The machine weighs 23.8 kg / 52,5 lb (THOR
41K PFC).
INSTRUCTION FOR
INSECURE POSITIONING
Failure to properly secure the machine can cause
personal injury.
If machine is in an insecure position do not attempt
to switch on.
Do not put the machine on an unlevelled surface
greater than 10°.
FRONT PANEL DESCRIPTION
1 Machine Live LED
2 Welding enabled LED
3 Excess temperature LED
4 Protection alarm LED
5 Air presence LED
6 Cutting current regulation
7 RESET button
8 Internal or External Compr. Switch
9 Air test button
BUILT-IN COMPRESSOR
This machine has a built-in air compressor that
allow to operates in areas where an external
primary air is not available. Only an electrical
mains supply 230V 1f is necessary.
STARTING UP
During use of the machine the operator must stand
at the front so as to prevent the fumes produced by
cutting from being sucked into the machine by the
cooling fans (through the front and side ventilation
openings.
WARNING!
If operate with external air, be sure to select the
external compressor (internal compressor OFF)
switch position in order to completely disable the
built-in compressor. Otherwise the compressor
may be damaged by the probable greater pressure
of the external air.
WARNING!
A pre-gas of 2 seconds after pressing the torch
button alerts the operator of the imminent start
of the pilot arc
.
CURRECT CUTTING
POSITION
The operator may start up the machine only after
having read and understood all parts of this
manual.
Depending on the type of cut to be
performed he must follow the work phases
described below.
WARNING!: A pre-gas 2 seconds after pressing
the torch button to alert the operator of the
imminent start of the pilot arc
.
INSTRUCTIONS FOR USE
1- Ensure that the work environment and your
clothing satisfy the safety requirements described.
2- Position the generator in a place where there is
no obstacle to air circulation.
3- Connect the THOR to a suitable power socket
(an earthed socket is obligatory).
4 - Connect the compressed air pipe to the coupling
on the rear panel.
For the instructions below, refer to the details
given:
With the potentiometer for regulating the output
current, set a suitable value for the thickness that
is to be cut, in agreement with the line capacity.
- Turn the switch ON/OFF in position ON.
- the green led will light up (machine live).
- the green led will light up to indicate the presence
of compressed air in the air circuit (only with
external compressor).
WARNING!
THIS UNIT USES ONLY COMPRESSED AIR. CHECK THAT
THE CONTAINER HAS NOT BEEN DAMAGED (IT COULD
EXPLODE). THE MAXIMUM PRESSURE IS 10 BAR. THE
MAXIMUM TEMPERATURE WITH WHICH THE UNIT CAN
WORK IS 40°C.
- The red Led is lit;
ATTENTION press the RESET button
-The red Led switches off
-When the yellow Led is off it means that the
THOR working temperature is within normal values
-With the TEST GAS button
check that the