Set-Up
Note: To perform the installation using the Installer Remote, you will need a connected display to
show the on-screen menu (OSD). If a screen is not available, or if you prefer to perform the web-
based installation, use the laptop PC and the wireless router in the Installer’s Kit to set up the Model
P1. Both setup procedures are explained in this manual.
Set up your Steinway Lyngdorf Model P1 Surround Sound Processor by following these steps in this
order:
1. ID-assign all Model A1/A2 amplifiers via dip-switches on A1/A2 socket panel according to the
wiring diagram for the installation.
2. Check that the mains voltage switch on the A1/A2amplifiers are correctly set to either 115V or
230V. The Model P1 will automatically detect the voltage and does not have a mains voltage
switch.
3. Connect speakers to the Model A1/A2 amplifiers.
4. Connect Model A1/A2 amplifiers to Model P1 and to each other as shown in the project-
specific wiring diagram included with every Steinway Lyngdorf system.
5. Connect external audio and video sources to the Model P1.
6. Connect power to the Model P1, the amplifiers, and all connected audio and video sources.
7. Switch on the Model P1 with the installer remote.
8. Access Installer menu via Web or via the Installer Remote.
9. Load Speaker Configuration file, page 19.
10. Verify Setup, page 20.
11. Check speaker phases, refer to speaker installation manuals
12. Run RoomPerfect™ Guided Set-up.
See
RoomPerfect™ Installation Manual
for more information.
13. Set up sources, page 21.
14. Optional: Add remote control in the P1 Remote Control Setup, page 33.
15. Save and back-up settings.
These steps complete the basic Model P1 set-up. For further programming options (zone set-up etc.)
refer to the Table of Contents.
13
