Use the Installer Remote to Name Sources
In the
Source Setup
menu you can name sources you have connected to the Model P1. This is done
using the arrow buttons on the Installer Remote. When you have selected the
Edit
option in the
menu, press the up or down arrow buttons to highlight the source you wish to rename, then press
OK
.
You can then do the following:
•
Press the left arrow or the
BACK
button to delete a character.
•
Press the up or down buttons repeatedly to browse through characters. Digits, lower-case
letters, upper-case letters, and punctuation characters (including space) are available.
•
Press the right arrow button to select the highlighted character and move to the next
character.
•
When the source name is complete, you can store the name selecting the carriage return
symbol (
↵
) from the character list and pressing
OK
.
Changing the Batteries
The installer remote is shipped with two AAA batteries. If the
Model P1 does not respond to remote control commands, it
may be because the remote control batteries need to be
replaced. Use a cross-tip (PH1) screwdriver to remove the
locking screw from the battery compartment.
The locking screw is at the base of the remote control, just
below the CE-label. When you have removed the locking
screw, the battery compartment is automatically ejected from
the bottom of the remote control. Remove the used batteries
and replace them with two AAA-size alkaline batteries. Insert
the battery compartment and tighten the locking screw.
12
