Jet Light
| 2014_V1
Page 5 of 26
EN
See Figure 4
Position 1: 1 ½” Fitting
Position 2: O-Ring
Position 3: Washer
4. Connect 1.5” fitting to the light assembly head and make
sure an o-ring is installed and screw it tight enough to pre-
vent any leaking.
See Figure 4
Position 1: 1 ½” Fitting
Position 2: O-Ring
Position 3: Washer
5. Disconnect the clamp on the hose. Unscrew the hose adap-
tor from the existing fitting and screw to a 1.5” Fitting.
See Figure 5
Position 1: Hose Adaptor
Position 2: 1 ½” Fitting
Position 3: Pool Wall
Position 4: Light Assembly Head
6. Connect the hose to the hose adaptor.
See Figure 6
Position 1: Hose
Position 2: 1 ½” Fitting
Position 3: Pool Wall
Position 4: Hose Adaptor
Position 5: Light Assembly Head
7. Connect the quick wire connection as Figure 7.
STORAGE AND WINTERIZING INSTRUCTIONS
It is common practice to drain the water level to a point below the
skimmer and the light, for winterizing
For storable pools: remove power from the unit by taking the power
cords’ three-prong plug and disconnecting it from its electrical outlet.
For permanent pools: turn off all electrical power supplying the light
circuit at the main circuit breaker.
Disconnect the quick connector on the wire and unscrew the light
assembly head from the wall flange and store it for next season.
Keep this manual. Please include the manual with the product upon
transfer of ownership.
Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
FR/IT/CZ/HU/HR/SK/SLO/RO/BG/TR: +43 (0) 7262 / 61431-0
e-mail: [email protected]
www.steinbach.at
