Jet Light
| 2014_V1
Page 4 of 26
EN
Warning
Before installing this product, read and follow
all warning notices and instructions accom-
panying this light. Failure to follow safety
warnings and instructions can result in severe
injury, death, or property damage.
Important Notice
Attention Installer.
This manual contains important information about the installation,
operation and safe use of this product. This information should be
given to the owner/operator of this equipment.
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical
equipment, basic safety precautions should
always be followed, including the following.
This light can be installed on storable above
ground or permanent above ground pools.
A permanent pool has a maximum water
depth of over 42 inches. Do not install on
therapeutic pools, hydro-massage bathtubs,
spas or hot tubs.
To reduce the risk of electric shock, if any
cord becomes damaged, return the entire
transformer assembly for repair or replace-
ment.
Risk of entrapment, injury or death. Use
plumbing passageways only to return water
to pool. Do not use as a suction device.
Risk of electrical shock. Connect only to a
grounding type circuit protected by a ground
fault circuit interrupter (GFCI). Contact a li-
censed electrician if you cannot verify that the
receptacle or circuit is protected by a GFCI.
Do not use an extension cord.
Locate your pool so that the wall is at least 10
feet from all electrical receptacles and at least
20 feet from all receptacles not protected by a
GFCI. It is also very important to locate the
pool so that it is not under any electrical wir-
ing that is less than 18 feet vertically above
the pool wall and within an area located 10
feet outside the pool walls. The pool must al-
so never be located under any lighting fixture
or within five (5) feet measured horizontally
from any fixture mounted less than five (5)
feet vertically above the pool water level.
Risk of injury. Install the top of the lens with a
minimum of 8 inches and a maximum of 10
inches below top of pool wall or in manufac-
turer’s pre-punched return fitting hole.
Warning
Risk of electric shock. Disconnect power be-
fore servicing this unit. Failure to disconnect
power can result in death or severe personal
injury. CONNECT ONLY TO A CIRCUIT
PROTECTED BY A GFCI. Failure to do so
can result in serious personal injury and /or
death.
Technical Details
Mounts easily into your return fitting.
Does not restrict water flow.
6 pieces of high-quality diodes (LED).
Equipped with transformer 230VAC input and 12VAC output 6W.
Total cord length 7M. For steel wall above ground pool or wooden
pool.
SPECIFICATION FOR TRANSFORMER: Input:230V 50HZ; Out-
put:12V 500MA 6W
Installation
For existing pool
Drain water level to be below the returning fitting
1. Unscrew the light assembly head from the threaded wall
flange.
See figure 2
Position 1: 1 ½” Fitting
Position 2: O-Ring
Position 3: Washer
Position 4: Big Rubber Gasket
Position 5: Light Assembly Head
Warning: Please do not open the light assembly head. Open the
head will void the warranty.
2. Remove the existing eyeball fitting including eyeball, eyeball
nut & eyeball base from the return fitting on your pool wall
See Figure 3
Position 1: Hose
Position 2: Pool Wall
Position 3: Liner
Position 4: Existing Eyeball
Position 5: Hose Adaptor
Position 6: Return Fitting Nut
3. Screw the light assembly head in the threaded wall flange.
Make sure the big rubber gasket is installed to prevent the
damage to the line.
