D1
- 8 -
D1 9/2011
Operators Manual for Drilling Machine
Basically annular cutters are designed to make through holes. On occasions
when there is a need for an overlapping hole the pilot should not be used.
5.1.1 Installing and uninstalling the annular cutter
Annular cutter installation and uninstallation should be carried out
when the machine is turned off and the power cord is unplugged!
Installing the annular cutter:
1. Raise the drive and the slide (2) up using the lever (3);
2. Raise the guard (1) to the maximum height in order to attain access to the
screws (5) in the spindle (4);
3. Insert the appropriate type of pilot (6) into the annular cutter (7);
4. Position the annular cutter (7) with the cutter facing up, so that the flat sides of
the cutter are facing the screws (5)
5. Put the annular cutter (7) into the spindle socket (4);
6. Tighten both screws securely (5).
Uninstalling the annular cutter:
1. Raise the drive and the slide (2) up using the lever (3);
2. Raise the guard (1) to the maximum in order to attain access to the spindle (4)
screws (5).
3. Loosen the screws (5);
4. Remove the annular cutter (7) and the pilot (6) from the spindle socket (4).
