D1
- 6 -
D1 9/2011
Operators Manual for Drilling Machine
and 32 A fuse for 120V.
When used on building sites, it must be supplied
through a separation transformer made in the second class of protection.
3)
Machine can be used outdoors, but is not weatherproof. Do not expose to rain,
snow or frost.
4)
Machine should not be used on: rusty surfaces, steel plates with thick covered
with paint, uneven surfaces or next to a welding machine.
5)
In all cases, always use a safety chain/strap (see drawing 1). The safety chain
should be tight! To avoid this situation the safety chain should be wrapped
around the element it is hooked to.
6)
Do not use the machine in explosion hazard zones.
7)
Do not start work if the machine has excessive play on guide slides.
8)
Always wear safety goggles and ear protection.
9)
Do not remove metal chips with bare hands.
10) Do not touch the spindle and the cutter during work.
11) Tools must be fastened firmly. When an annular cutter is used, check before
start of work to ensure tool holding screws are tight.
12) Do not use dull or damaged tools.
13) Do not use annular cutter without pilots, and arbors without ejection spring.
14) Use tools recommended in Operator’s Manual only.
15) After use, always clean metal chips and coolant from drilling machine.
16) Always unplug the machine from the power supply before doing any work on the
machine.
17) In the event that the machine falls on a hard surface, from a height, is wet or is
subjected to other unfortunate events that could affect its technical state - work
should be terminated immediately and the machine should be sent to service for
inspection as soon as possible.
Do not use D1 drill on steel thinner than (3/8”, 10 mm). On thin steel
(less than 3/8” (10 mm)) magnet’s adhesive power is significantly reduced
which can cause machines failure or individuals injury. The entire surface of
the electromagnetic base should be located on the work piece!
It is recommended that the surface under the electromagnetic base be
sanded down with abrasive paper, before positioning the machine!
