Rail Runner LT
Rail Runner LT
– Operator’s Manual
19
3.7. Operating
Set
the
travel
direction
switch
and
arc
ignition
switch
to
‘O’. Next, set the power switch
to ‘I’ to turn on the power. The whole display will then lit (
). Then,
shows (for
centimeters per minute) or
(for inches per minute). Next, the carriage speed
shows. Use the knob to set the required speed.
To control the torch through the carriage,
set the arc ignition switch to ‘I’.
Use the travel direction switch to select a direction of travel. Then, the travel
starts with the speed that is shown. You can adjust the speed at any time.
To stop the travel, set the
travel direction switch to ‘O’.
After the work is finished, use the power switch to turn off the power. Then,
unplug the carriage from the power source.
If the arc ignition switch is set to ‘I’, the torch starts welding /
plasma cutting promptly after selecting a travel direction.
