D2X
D2X Operator’s Manual
7
20. Do not start operation if the gib clearance is excessive.
21. Use
the
safety chain in all operating positions. Attach the machine to a fixed
structure by fastening the chain to the lugs or the carrying handle. The chain
must not be loose. Wrap the chain around the workpiece if possible.
22. Before every use, inspect the machine to ensure it is not damaged. Check
whether any part is cracked or improperly fitted. Make sure to maintain proper
conditions that may affect the operation of the machine.
23. Always use eye and hearing protection and protective clothing during operation.
Do not wear loose clothing.
24. Proceed
with
caution
when
drilling
plates
with a
thickness
less
than
10
mm
(0.4’’)
because the holding force depends on material thickness and is significantly lower
for thin plates.
25. The entire bottom of the electromagnetic base must be in full contact with the
workpiece. Before every positioning, wipe the workpiece with coarse-grained
sandpaper.
26. Do not touch moving parts or chips formed during milling. Prevent objects from
being caught in moving parts.
27. After
every
use,
remove metal
chips
and excess coolant from the machine. Do
not remove chips with bare hands.
28. Cover steel parts with a thin anti-corrosion coating to protect the machine from
rust when not in use for any extended period.
29. Maintain the machine and install/remove parts and tools only when the machine
is unplugged from the power source.
30. Repair only in a service center appointed by the seller.
31. If the machine falls from any height, is wet, or has any other damage that could
affect the technical state of the machine, stop the operation and immediately
send the machine to the service center for inspection and repair.
32. Never
leave
the
machine
unattended
during
operation.
33. Remove from the worksite and store in a secure and dry location when not in
use, previously removing the tool from the holder.
