Page 46 of 46
939564902 Rev F
®
Guidelines on Moving Benches
NEVER
move units while they are still ganged together inline. Always disconnect the power & data, and
seperate the inline connectors first (see artwork below).
When possible, the bench should be moved in a horizontal (flat) position.
If the bench must be moved vertically (i.e. standing on a pallet), care must be taken to ensure no side
pressure is placed on any of the lifting columns as it is tipped into position, during transport, and when
tipped off the pallet at the new location.
To avoid damage, remove lifting column covers/shrouds if the bench must be moved vertically or tipped
upward at an angle greater than 30
o
.
Before in use in the location, the bench must again be completely leveled side-to-side and front-to-back.
Failure to do so may cause binding of the lifting columns and failure to operate properly.
After moving, the lifting columns must be re-synchronized by holding 'down' arrow on the Controller
while the lifting columns seek to level themselves (Series 8 only).
2
3
4
5
1
6
