Page 24 of 46
939564902 Rev F
®
Attaching the Controller
4
NOTE:
Push button stick-on controller
installation is shown below. However, the
controller cannot be installed until the
worksurface is flipped over. Once step 18 is
performed, the controller may then be
installed.
NOTE:
Remove paper backing from contoller
before installation.
Digital Desk
Panel Controller
Standard
Controller
Install the Controller to the underside of the worksurface on the
side preferred by the user, using the pre-drilled pilot holes. Plug
the RJ-45 end into either port on the Control Box.
Push Button Stick-On
Controller
PAPER BACKING
CABLE CLIP
5
Install the cable clips for the control wire. Peel
off paper backing and stick to worksurface.
Place wire into each cable clip.
5
#2 SQUARE
DRIVE
#8 x 5/8 SCREW
(SILVER)
Series 8 Bench Assembly (cont.)
