Page 18 of 46
939564902 Rev F
®
1a
Attach driveshaft covers using four (4) screws each,
1
Attach Driveshaft Covers and
To maximize available space on the back of the worksurface
2
into the pre-drilled pilot holes.
NOTE:
There should be about 1/4" between the motors
and the driveshaft covers.
Wire Managers
for clamping accessories, place the wire manager over the
driveshaft cover as shown. Attach with either two (2) or
Athree (3) screws.
COVER
WIRE MANAGER IS
PUSHED UP AGAINST
DRIVESHAFT COVER.
BACK OF
WORKSURFACE
ALIGN HOLES IN COVER
WITH PILOT HOLES IN
WORKSURFACE.
~
1/4"
MOTOR
DRIVESHAFT
COVER
ROUTE SWITCH CABLE
THROUGH THIS AREA
NOTE:
The cover is eliminated on assemblies with a
Power & Data Tray.
2
WIRE MANAGER
#2 SQUARE DRIVE
WORKSURFACE SCREW
Series 5 Bench Assembly (cont.)
NOTE:
Assemblies with a Nexsis Power Access Door
Package do not use a driveshaft cover.
NOTE:
Assemblies with a Nexsis Power Access Door
Package require the Wire Manager to be installed at
an alternate location as shown.
1b
TWO SCREWS
PER SIDE
WIRE MANAGER
