Page 3 of 18
939599301 Rev B
Mounting Corded Power Module
to the Base Frame
It is preferred to do this before installing
components on the top of the Base Frame for
easier access.
1.
Determine the front of the Base Frame and
locate the power module in the desired location on
the underside of the base frame front rail. Check
power cord length to make sure the desired
location enables it to reach the building power
outlet safely.
2.
Slide power module onto bracket and tighten
thumb screw to clamp it in place.
3.
Place module with bracket in its position and
mark hole locations. Two options: 1) drill 1/8”
diameter pilot holes through the entire front rail
from the front, or 2) drill 1/8” diameter pilot holes
through the back of the front rail. Deburr holes on
the back face of the rail.
4.
Place module on the back face of the base
frame front rail and install fasteners. Tighten
fasteners securely.
5.
Plug power cord into outlet and manage
extra cord under the base per local codes.
POWER
MODULE
2
3
4
1/8”
NOTE: A rail here on the
88”W unit prevents drilling
from the inside outward.
MOUNTING
BRACKET
NOTE: Orient with power
cord on top as shown
®
HEALTH
