MAINTENANCE AND CLEANING
Regularly clean dust and dirt from lifting columns. To ensure all surfaces are
thoroughly cleaned, make sure the lifting columns are fully extended to their
maximum height. Also, be sure to inspect cables and lifting columns for
damage. Check all connections for both correct function and secure mounting.
Caution:
A damp cloth is recommended. To protect the painted surfaces, use a
cleanser that is not highly alkaline or acidic. A pH-neutral product is ideal.
Note:
Please do not move the desk without help. Refer to the guidelines at the
end of the assembly instructions, or contact your facilities group for assistance.
TROUBLESHOOTING
If you are having trouble with your desk, try the simple steps outlined below.
If problems persist, please refer to the Migration SE troubleshooting guide.
DESK WILL NOT FULLY ADJUST
•
Check that the power cable is fully plugged into the outlet.
•
Check that the power cable is fully plugged into the control box under the desk.
•
Check that the desk is not overloaded. The weight load should be evenly
distributed.
•
Synchronize the lifting columns as outlined on the next page.
POWER-SAVING CONTROL BOX:
•
The control box automatically powers down into ‘standby’ mode after
20 seconds of inactivity.
•
During standby mode, the control box only consumes 0.2 watt of power.
•
With the control box in standby mode, the desk can lose power without
affecting the synchronization of the lifting columns. However, a power loss still
allows the control box to power down and ‘soft reset.’ (see below)
CONTROL BOX SOFT RESET:
•
Unplugging the control box from the power source, and then plugging it
back in, interrupts power to the processor inside the control box. This power
interruption causes the processor to reset.
•
If the desk experiences an unexplained freeze or erratic performance,
unplug the control box from the power source to cut power to the processor,
and reset its routine. Wait a minimum of 5 seconds, and then re-connect
the power.
•
If this does not restore normal performance, additional troubleshooting steps
are required.
