STORE HEIGHT INTO MEMORY
•
Adjust the desk to the position you want to save. The display will show the
desk height.
•
To store the height:
A. Press the
save
button. The display will read
s
.
B. Press the required memory position button. The display will read
s#
(e.g.,
s2
).
C. After 2 seconds the saved desk position will be displayed.
SWITCH DISPLAY FROM INCHES TO CENTIMETERS
A. Press memory positions
1
,
2
, and the
up
button simultaneously until the
display shows
s5.
B. Press the
save
button once; you will hear two clicks.
C. Units of measure now changed from whatever it started as.
(cm to inches, or inches to cm).
ENABLE AND DISABLE BUTTON LOCK
•
The button lock can be enabled or disabled by swiping the screen.
•
After enabling the button lock, a button will be shown on the display.
ERROR CODES
•
In the event of a fault, the digital display may show an error code. Refer to
the troubleshooting guide.
CABLE MANAGEMENT
When installing equipment, either on the worksurface or below, be sure that
the connecting cables are free from obstruction. Clips and ties are provided to
manage excess control box and base controller wires and can be attached to
the underside of the worksurface. Use these clips and ties to minimize possible
entanglements and achieve a clean aesthetic.
WORKSTATION DESIGN TIPS
•
Ensure that power cords for all accessory items – computer, lights, monitors,
etc. – are of sufficient length to reach outlets throughout the range of
worksurface height adjustment. Do not subject the cords to any strain while
height adjustment is taking place.
•
Always check for proper operating clearance before placing any item on,
above or below the worksurface.
4 Preset Programmable Controller with Digital Display
